Univention Bugzilla – Bug 47332
The s4-connector is never restarted during setup if installed prior to ucs@school
Last modified: 2018-09-11 11:34:17 CEST
The s4-connector is never restarted during setup if installed prior to ucs@school A lot of ucr variables that are set during the @school setup take only effect after an univention-s4-connector restart. For example connector/s4/mapping/group/syncmode=write
[4.3 cc1bc5e52] Bug #47332: restart s4-connector to activate new config [4.3 d16ed4260] Bug #47332: yaml
The connector restart has not been in the join sripts / postinst, because a system restart is assumed. The documentation says: ------------- Installation und Konfiguration von UCS@school sollten mit einem Neustart des Systems abgeschlossen werden. ------------- But a) it doesn't say it's mandatory, and b) I think it's good the installation puts the system in a correct state as much and early as possible. A restart may still required, because if the connector was not running, it won't be started by the "try-restart". OK: code change
UCS@school 4.3 v5 has been released. https://docs.software-univention.de/changelog-ucsschool-4.3v5-de.html If this error occurs again, please clone this bug.